Operating instructions

-114-
Error Explanation Code Solution
Hopper stops
Interlock on the side of the
paper-feeding roller operated.
R1
• Release the interlock switch.
• Press the CLEAR switch
(or execute the clear error
command).
Drawing out error
Sheet was pulled out after it
was fed.
R2
Press the CLEAR switch
(or execute the clear error command).
Timeout
A sheet wasn't fed within the
set sheet insertion duration.
R3
Press the CLEAR switch
(or execute the clear error command).
Timing mark error
Only three or fewer timing
marks were detected on the
front side of the read sheet.
R4
•
Check the
direction of the sheet .
• Press the CLEAR switch
(or execute the clear error
command).
Only three or fewer timing
marks were detected on the
back side of the read sheet.
Setting error
When reading front side marks
using a timing control type, the
next timing mark is detected
within the area set by the
control multiple number.
R5
•
Set a reading type and a control
multiple number according to
paper specifications.
• Press the CLEAR switch
(or execute the clear error
command).
When reading back side marks
using a timing control type, the
next timing mark is detected
within the area set by the
control multiple number.
Black level error
There is light colored stain on
the front side reading unit.
S2
Press the CLEAR switch
(or execute the clear error command).
There is light colored stain on
the back side reading unit.
Reading start detection
sensor soiling error
There is stain on reading start
detection sensor.
S3
After cleaning the sensor section
turn the power switch on again.
(3) Operation errors
Error displays and countermeasures
SR-3565(E).indd 114SR-3565(E).indd 114 2007-8-16 10:21:272007-8-16 10:21:27