Operating instructions

-113-
[Stacker unit]
Error Explanation Code Solution
Jam at printer printing
start detection sensor
A paper jam occurred at the
printer printing start detection
sensor.
I1
• Remove jammed paper.
• Press the CLEAR
switch
(or execute the clear error
command).
Jam at main paper
discharge sensor
A paper jam occurred at the
main paper discharge sensor.
I2
• Remove jammed paper.
• Press the CLEAR switch
(or execute the clear error
command).
Jam at selected paper
discharge sensor
A paper jam occurred at the
selected paper discharge
sensor.
I3
• Remove jammed paper.
• Press the CLEAR switch
(or execute the clear error
command).
2. Warnings
(1) Components
(2) Paper feeding
Error Explanation Code Solution
Back side reading unit
unconnected
Back surface reading unit is
not installed.
P1
• Check if the back side
reading unit is installed.
• Press the CLEAR
switch
(or execute the clear error
command).
Barcode unit unconnected
• Barcode unit is not connected.
P2
• Check if the Barcode unit is
installed.
• Press the CLEAR
switch
(or execute the clear error
command).
Printer unit unconnected
• Printer unit is not installed.
• P
rinter cartridge is not installed.
P3
• Press the CLEAR switch
(or execute the clear error
command).
• Set printer control invalid.
Stacker unit unconnected
Stacker unit is not installed.
P4
• Check if the Stacker unit is
installed.
• Press the CLEAR switch
(or execute the clear error
command).
Error Explanation Code Solution
Sheet empty
There is no paper in the hopper
or the internal units.
Q1
Press the CLEAR
switch
(or execute the clear error command).
Double feed error
Two or more sheets were fed
simultaneously.
Q2
Press the CLEAR switch
(or execute the clear error command).
Left end skew error
Paper was fed crookly.
Q3
Press the CLEAR switch
(or execute the clear error command).
Error displays and countermeasures
SR-3565(E).indd 113SR-3565(E).indd 113 2007-8-16 10:21:262007-8-16 10:21:26