Item Brochure

TEST PROCEDURE

STEP 3

Immediately put the swab into the Test Tube.

Vigorously mix the solution by rotating the swab forcefully

against the side of the Test Tube at least ten (10) times.

Best results are obtained when the specimen is vigorously

extracted in the solution.

Let stand for 2 minutes.

STEP 2

Vigorously shake the Extraction Reagent

Bottle 3 – 5 times to mix the contents. The

liquid in the Extraction Reagent Bottle

should turn from pink to light yellow.

Add only 6 drops of the Extraction

Reagent to the Test Tube.

STEP 1

Just before testing, squeeze the Extraction Reagent Bottle

to crush the ampule inside. Note: The ampule must be

crushed before proceeding to the next step.

STEP 5

Remove the Test Stick(s) from the container;

re-cap the container immediately.

Place the Absorbent End of the Test Stick into the

extracted sample.

STEP 6

Read results at 5 minutes. Positive results may be read

as soon as the red Control Line appears. Negative results

must be conﬁrmed at 5 minutes.

Results are invalid after the read time.

The use of a timer is recommended.

STEP 4

Express as much liquid as possible from the swab by

squeezing the sides of the tube as the swab is withdrawn.

Discard the swab.

Absorbent End Result Window Handle End

2 min

5 min

10x

6 drops

Note:

Adding more than 6 drops during this step

may provide erroneous results