User manual

User Manual

Fig. 4.3.1 - The BB 50/200Installation

♦ Fix the BB 50/200 to the mounting location using the four screws (holes

diameter 4 mm), see Fig. 4.3.2.

♦ Route the CHART PLOTTER cable to the chart plotter.

♦ Mount the transducer according to the instructions provided with it.

♦ Connect the POWER cable to the battery. Please be advised that the

BB 50/200 when not operating will remain in Stand-By mode.

4.3.2 Installing Optional Devices

See the External Connection diagram.

4.4 STATUS LED

There are seven different LED behaviors, representing seven different diagnostic

conditions. These are described below.

♦ 1. BOOTLOADER

LED Behavior: OFF

The BB 50/200 is running in the bootloader, or is not powered on at all.

♦ 2. STANDALONE DST, NO TRANSDUCER MODE

LED Behavior: ON, steady

The BB 50/200 is in Standalone DST (Depth, Speed, Temperature) mode,

but is not pinging because Transducer ID has not detected a trans-

ducer. This condition will occur if there is no communication with the

chart plotter, and no transducer is connected.

♦ 3. STANDALONE DST

LED Behavior: 1 long flash every 2 seconds

The BB 50/200 is in Standalone DST mode, and is pinging normally.

This condition will occur if a transducer is connected properly, but there

is no communication with the chart plotter. In Standalone DST mode,

the NMEA 0183 output produces standard NMEA Depth, Speed, and

Temperature sentences.