User`s guide

4-44
6
Press key. Then the adjustment
pattern shown in the gure below is
printed.
#T EST P RIN TS
*
EX ECUTI NG
media advance direction
[LS ADJ PRINT] print sample
Blank area
Media feeding direction
Media feeding direction
Blank area
Measure the blank area with 15mm as the reference value to obtain
the adjustment correction value.
• How to measure the “LS ADJ TOP VAL”
<Example>
When the blank area is 14mm : The adjustment correction value will be –1.0mm.
When the blank area is 16mm : The adjustment correction value will be +1.0mm.
Measure the length (blank area) between
the adjustment pattern and the cut
media.
• How to measure the “LS ADJ SIDE VAL”
• How to calculate the adjustment correction value
Measure the length (blank area) between the
adjustment pattern and the edge of the media.
IP-5610取説_E.indb 44 09.4.3 3:15:32 PM