Specifications

Confidential
EPSON
TITLE SHEET
REVISION
NO.
SHEET NEXT
E
TM-T90
Specification
(STANDARD)
25 24
NOTES: 1. A prefix “n” to signal names refers to “L” active signals. To the host not provided with all
of the signal lines listed above, both-way communication fails.
2. For interfacing, signal lines shall use twisted pair cables with the return sides connected
to signal ground level.
3. Interfacing conditions shall all be based on the TTL level to meet the characteristics
described below. In addition, both rise time and fall time of each signal shall be
0.5 µs or less.
4. Data transmission shall not ignore the signal nAck or Busy. An attempt to transmit data
with either signal, nAck or Busy, ignored can cause lost data.
5. Interface cables shall be as short in length as possible.
2.1.2.4 Electrical characteristics
DC Characteristics (Except Logic-H, +5 V Signals)
Specifications
Characteristics Symbol
Min Max
Conditions
Output HIGH voltage V
OH
*2.4 V 5.5 V *I
OH
=0.32 mA
Output LOW voltage V
OL
-0.5 V *0.4 V *I
OL
=-12 mA
Output HIGH current I
OH
0.32 mA - V
OH
=2.4 V
Output LOW current I
OL
-12 mA - V
OL
=0.4 V
Input HIGH voltage V
IH
2.0 V -
Input LOW voltage V
IL
- 0.8 V
Input HIGH current I
IH
- -0.32 mA V
IH
=2.0 V
Input LOW current I
IL
- 12 mA V
IL
=0.8 V
Logic-H Signal Sender Characteristics
Specifications
Characteristics Symbol
Min Max
Conditions
Output HIGH voltage
Output LOW voltage
V
OH
V
OL
3.0 V
-
5.5 V
2.0 V While the power is OFF