Specifications

8-1
8
LOADING/UNLOADING PAPER AND HEAD CLEANING
8.1 LOADING/UNLOADING PAPER PRECAUTIONS
①
①①
① Loading paper
 Load paper with the thermal head in the up position.
(See Figure 8-1 Head Cleaning Procedure (b) in Section 8.2 “HEAD CLEANING
PROCEDURES AND PRECAUTIONS”).
 Cut the edge of the paper so that the center of the paper will be inserted first
 Insert the paper straight into the paper inlet.
 When the edge of the paper comes up from between the thermal head and the platen, pull the
edge of the paper, check whether the paper is aligned correctly, and place the thermal head into
the down position.
②
②②
② Unloading paper
 Unload paper with the thermal head in the up position.
(See Figure 8-1 Head Cleaning Procedure (b) in Section 8.2 “HEAD CLEANING
PROCEDURES AND PRECAUTIONS”).
 Pull the paper straight up by hand in the direction in which the paper is normally fed.
 If the paper is bonded on the core of the paper roll, separate the paper from the core and then pull
the paper out.
CHAPTER
NO GOOD NO GOOD NO GOOD
GOOD