Specifications

6-2
6.2 LAYOUT OF PRINTER AND PAPER
 Design the paper outlet angle in 0 to 45°. (See Figure 6-1)
Figure 6-1 Paper Layout
6.3 WHERE TO MOUNT THE PAPER HOLDER
When determining the layout of paper holder, note the following:
 When you use a paper roll, set the holder so that the paper is in alignment with the paper intake
with no horizontal offset, and that the center axis of the paper roll is parallel with the printer.
 Keep the paper feed force 50 gf or less.
6.4 WHERE TO MOUNT THE PAPER CUTTER
Install the paper cutter so that it does not interfere with the paper feed. The angles and positions for
feeding paper are shown in "CHAPTER 7 APPEARANCE AND DIMENSIONS".
 If the distance between the edge of the thermal head and the edge of the fed paper is too small,
the paper may be caught by the platen. Please take this into account when designing.
 Use a cutter with a sharp edge so that paper is cut with the paper hold force or less.
PAPER DETECTOR
THERMAL PAPER ROLL
The distance between the paper
detector and the heat element is
approximately 8 mm.
THERMAL HEAD
PLATEN
MOUNTING FACE
HEAT ELEMENT
Paper outlet angle (θ) : 0°≤θ≤45°
θ