User`s manual
118
LP-1030-MF User's Manual for Multifunction Printer Operation
Before Use Copy Function
Submission
Function
Preset Functions Scan Function Troubleshooting
1
2
3
4
5
6
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
For example, against the settings below to partially copy an A3 portrait
original, the Printer generates a warning message:
- Partial copy start position to 1000 mm (39.37 inches); or
- Partial copy start position to 100 mm (3.94 inches) against the
original length to 10000 mm (393.70 inches)
A.
The distance specied below is longer than the original length.
From: Original's front end
To: Partial copy start position
Specify the distance above so that it does not exceed the maximum
scannable length.
Q.
Cannot erase the frame. Or, the frame is not erased as expected.
A.
Frame suppression is aected by the scale setting.
On erasing the frame with the scale activated, the frame suppression
amount is aected by the scale setting.
Specify the frame suppression amount, considering that the amount is
scaled up/down according to the scale setting.
Q.
Cannot add blank space. Or, blank space is not added as expected.
A.
The Original Size is set to Auto, Portrait, or Landscape.
When Original Size is set to Auto, Portrait, or Landscape, adding blank
space is disabled.
Set Original Size to Synchro Scan.
A.
This is not aected by the scale setting.
When adding blank space, the scale setting does not aect the amount
of added blank space. Set the amount of blank space without taking the
scale setting into account.