User`s guide

2-47
Chapter 2 Basic operations
(3) Place the roll in the drawer
Load the roll of the 8.5×11 inch series to be used into the roll paper
drawer.
See page 2-16 for instructions on loading the paper roll.
When using the cut paper of the 8.5×11 inch series, this step is not
needed.
(4) Setting the paper menu
Set the MEDIA SERIES of the drawer into which the roll of the 8.5×11
inch series was placed to the 8.5” SERIES (page 7-2).
When using the cut paper of the 8.5×11 inch series, this step is not
needed.
(5) PDL setup
Set the MEDIA SERIES of the PDL setup for the port to transfer the data
to 8.5” SERIES (page 5-11).
(6) If not operated as expected
If the preset series does not work as expected, check the process from
steps 1 to 5 again.
Note
◆All of the apply rolls of the same series cannot be set to OFF
at the same time.
◆If this setting is changed, the device must be restarted.
▼Using paper of new standard series