User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
2-42
Cancel printing
Press the [STOP] key during printing and the following Cancel message
will appear. After a Print cancel is processed, the display will return to the
Online display.
Press the [Enter] key.
Additional printing
In the data standby condition, the same drawing as that printed last
(called "accumulated drawing") can be additionally printed. At this time,
the number of copies can be also specified.
If no drawing has been stored or "accumulated", the device is not
activated.
The stored drawings can be erased by pressing the [RESET] key in the
data standby condition.
Press the [Reprint] key.
Press the [Enter] key.
No. of copies can be
changed using the key
pad (up to 20 copies).
Cance l Pr i nt?
F01 HPGL JobNo . 008
✽
Pr int Ready
Pr int Ready
Ext ra Pr i nt?
Cop i es
XX
[ENTER] TO EXECUTE
Ext ra Pr i nt XX/XX