User`s guide

2-30
Replacing the process cartridge
When the Process cartridge approaches the end of its life, the PROCESS
LED flashes and the following message appears. It is still possible to
continue to produce plots in this condition, but you must replace the
cartridge soon.
If a new pocess cartridge is not installed soon, the PROCESS LED goes
out, ERROR LED comes on and plotting becomes impossible. The
following error message appears on LCD.
When the PROCESS LED flashes or goes out, follow the procedures
indicated below to replace the Process cartridge.
Precautions during replacement
Warning
Do not throw the process cartridge into fire. Doing so may
cause accident and fire.
Dispose of process cartridge as non-burnable garbage.
Note
◆Above message may not appear in certain cases.
Pr int Ready
Rep l ace Process Ca r t r i dge
Se t
Process Car t r i dge