User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

2-27
Chapter 2 Basic operations
Caution
◆Do not drop and hit waste bottles containing waste toner.
Doing so may cause toner to leak.
◆Take care not to directly contact the waste toner. If the toner
gets on your skin or clothing, quickly wash it out with water.
◆Take care not to get the waste toner into your eyes or
breathe it in.
If waste toner gets into your eyes, wash your eyes out with
plenty of water and consult a physician.
Waste toner bottle replacement procedures
1 Take out a new waste toner bottle from its package and
remove the cap.
◆ This cap should be used to cover the waste toner bottle which
you are removing, so keep it at hand. ⇒ procedure 4.
2 Open the waste toner bottle door.
The waste bottle door is located at the right side of the device.
Notes
◆Replace the waste toner bottle after plotting has been
completed.
If replacement is attempted during plotting, the plotting data
may be lost.
◆The toner inside the waste toner bottle cannot be re-used.
▼Replacing the waste toner bottle