User`s guide

Table Of Contents
2-26
When the waste bottle is nearly full with waste toner, the WASTE
TONER LED will flash. Although plots can continue to be produced for
a little while longer, replace the waste toner bottle soon.
When the waste bottle becomes full with waste toner, the WASTE
TONER LED will go out. The ERROR LED will turn on and plotting
will not be possible. The following message appears on the LCD.
If the WASTE TONER LED starts flashing or the massage appears on
the Control Panel, replace the waste bottle in accordance with the
procedures outlined below.
A “Waste toner bottle replacement” label is affixed to the side of
the waste toner bottle. Refer to this when replacing the waste
bottle.
Even after the Waste toner LED starts flashing, you should be
able to produce about 120 m of plots.
Warning
Replacing the waste toner bottle
Precautions during replacement
Do not throw waste toner bottles containing waste toner
into fire.
Doing so may cause an accident and fire.
Dispose of waste bottles as non-burnable garbage.
Change
Wa s t e B o t t l e