User`s guide

2-21
Chapter 2 Basic operations
1 Open the scanner cover.
2 Remove the scanner exit guide.
Toner replacement procedures
▼Replacing the toner
Notes
◆The toner must be replenished with the device power in ON
status after the “Print Ready” is displayed. If the toner is
replaced while the power is Off, the device will not be able to
detect the amount of toner and an error status will not be
cancelled even when toner has been replaced correctly.
◆Replace toner after plotting finishes. Replacing the toner
during plotting may cause the operation to stop and data to
be lost.
Lift and then pull the guide
backward to remove while the
cover is open.
Lift the scanner cover up to its
stop position. Pull the stopper
towards the arrow direction and
raise the scanner cover. The
scanner cover will be held.