User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
2-10
The device is “ONLINE” when it can receive and print data from the host
computer and is “OFFLINE” when settings are being input on the control
panel. You must set the device to “offline” to operate the menu from the
control panel.
Online
To print from the host computer, the device must be online. Always make
sure that the device is online to print from the host computer. If the device
is not online, follow the procedures below to set the device online. The
device will automatically go online when the device power is turned on.
1 Press the [PRINT] key to turn the PRINT LED off.
Offline
To select menu operations and paper feed method etc. using the device
control panel, the device must be offline. Before using the control panel
keys, set the device offline according to the following procedures.
1 Press the [MENU] key to turn the MENU LED on.
Online and offline
Pr i nt Ready
Me nu M ode
MENU
#SETUP