User`s guide

2-5
Chapter 2 Basic operations
When a job is saved, the following message appears and the device stands
by for selection.
When a job is not saved, this message is omitted.
Under normal conditions, the display reads “Wait a moment” and is
changed to the following message.
The message is changed to “WARMING UP".
The message indicates that the device is now online (“Print Ready”).
In the “Print Ready” status, press the PRINT key or send data.
If a key input is not made,
this message will time-out
after about 10 seconds
and the device starts up
with the job in saved
condition.
Warm up will take about 4
minutes (about 8 minutes
with LP-1020L-MF).
nnn: a count down for the
warm up is displayed.
▼Turning the power on and off
Delete Job?
Y=En t e r N=Canc e l
Sys tem Vers i on
01A
Wa rmi ng up nnn
Pr i nt Ready