User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

2-3
Chapter 2 Basic operations
WARNING LIGHT
MENU
POWER
SAVING
COPY
DELIVERY
PRINT
FILE
ERRORDATA
ORIGINAL
SIZE
AUTO
FIXED-SIZE
PORTRAIT
FIXED-SIZE
LANDSCAPE
SYNCHRO
ORIGINAL
TYPE
BACKGROUND
REMOVAL
DENSITY
LIGHT
NORMAL
DARK
SCALE x1
FIXED SCALE
ZOOM
NON-PROPORTIONAL
SCALE
PAPER
FEED
ORIGINAL
IMAGE
QUALITY
SORT
FUNCTION
SCAN STOP
REPRINT
MEMORY
TEXT/LINE
BLUE PRINT
PHOTO
TEXT/PHOTO
POWER
START
RESET
STOP
TONER
PROCESS
MANUAL FEED
WASTE
TONER
◆While data is being processed, do not turn off the main
power switch. Doing so may damage the system.
◆When the power is on and the Main power switch is turned
off, or when the power goes out due to blackout etc.,
restoring the power (turning the Main power switch back on
or resetting from a blackout) is the first step, but will not turn
the plotter on. You must also turn ON the power key on the
control panel.
Main power switch
[POWER] key
Notes
Control panel
Turning the power on and off
This device has two power switches: the main power switch located at
the lower-left as seen from the rear of the device; and the power key on
the control panel.
The device power is turned on by first turning on the main power switch, and
then pressing the device’s control panel power key.