User`s guide

2-2
Plotting is usually conducted in accordance with the following
procedures.
For information on computer operations, refer to your computer manual.
1 Turn on the power for the computer and this device.
For information on turning on the device power, refer to “Turning the
power on and off.” (⇒ page 2-3)
2 Confirm the status of the device on the control panel.
Confirm that the LEDs are not indicating abnormalities and that the LCD
indicates Data standby status.
◆ When using the copy, delivery, or file function, see “User's
Guide, Copy Part” separately.
Press [PRINT] key when the MENU LED is on.
When the TONER LED is flashing or off, replace the toner. (⇒ page 2-19)
When the WASTE TONER LED is flashing or off, replace the waste
bottle. (⇒ page 2-26)
When the PROCESS LED is flashing or on, replace the process cartridge.
(⇒ page 2-30)
When the ERROR LED is on, refer to chapter 14 for information on
troubleshooting.
3 Open your application software on your computer and
create a drawing.
If the device settings do not conform to the application software you are
using, reset the settings for this device (⇒ Chapters 5 to 12).
4 Send the data from the computer to this device.
Plotting procedures overview