User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
1-18
Process i ng 02/99
Wa i t : 012
F01 HPGL JobNo . 008✽
Data standby display
How to read the status displays for this device
Data is being processed.
The various information for the data currently being processed is displayed.
This is a print ready status.
Standard configuration
Communication channel name
F : FTP protocol
L : LPD protocol
X : XPT protocol
PR : Parallel
USB : USB
Indicates that data is being processed.
(flashing)
Port number (this number is not displayed when using
parallel or USB interface.)
PDL name
HPGL
DSCAN
TIFF
CALS
Note
◆Parallel and USB are only displayed when each interface is
installed.
This section explains the control panel LEDs and LCD which inform you
of the status of the device.
The following are the main displays.
Data processing display
Pr i nt Ready
Print
Print
Number of prints executed
Number of prints scheduled
xxx: The job number being
processed
xxx: The job number standing
by for processing