User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

1-12
Right side/rear side
1 Main power switch Turns the device power on and off. (⇒ page 2-3)
2 Power cord Plug this cord into a power cord socket.
3 Parallel interface connector
This is an interface connector conforming to the standards of the
Parallel interface connector of Centronix.
4 Ethernet interface connector
This is an interface connector for a 100 BASE-TX and 10 BASE-T
Ethernet interface connector.
5
USB interface connector
This is an interface connector for a USB 2.0 interface connector.
6 Cutter door (door 5) Open this door to deal with paper jams at the cutter area.
(⇒ page 14-3)
7 Cutter door inside (door 9)
Open this door to deal with paper jams at the cutter area.
(⇒ page 14-3)
8 Cutter door lower small door (door 10)
Open this door to deal with paper jams at the cutter area.
9 Toner cover Open this cover when replacing toner. (⇒ page 2-19)
②
①
⑦
⑥
⑧
⑨
③
⑤
④