User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
Appendix-35
▼ Command list
Appendix
CALS Format Records
Symbols in the following table denote as follows:
™
: Denotes the record supported by this plotter.
× : Denotes the record not supported by this plotter.
◆ Only the TYPE I format is supported by this plotter. If the data of TYPE II is
received, the data is discarded.
◆ If a record not supported by this plotter is received, that record is ignored.
ftp Tag
The LP-1020 supports the ftp that transfers usual plot data and the anonymous ftp.
The anonymous ftp enables you to log in by entering "anonymous" in the user name. The
ftp for data transfer enables ten users to be logged in simultaneously, while the anony-
mous ftp enables one user to be logged in simultaneously.
droceRnoitcnuFtroppuS
epytr.epytatadehtseificepS
tneiror.gniwardfonoitatneiroehtseificepS
tnclepr.senilforebmunehtdnaenilrepstodehtseificepS
ytsnedr.hcnirepstodehtseificepS