User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
Appendix-20
*000.000.000.000
to *255.255.255.255
*000.000.000.000
to *255.255.255.255
*000.000.000.000
to *255.255.255.255
*000.000.000.000
to *255.255.255.255
K
#PORT SELECT 1-10
>XLF------------
#DHCP
>DISABLE
#IP ADDRESS
>000.000.000.000
#SUBNET MASK
>000.000.000.000
#ROUTING TABLE
#SETUP DETAILS
*X
*L
*F
*-
*DISABLE
*ENABLE
*000.000.000.000
to *255.255.255.255
*000.000.000.000
to *255.255.255.255
#GATEWAY ADDR01
>000.000.000.000
#NETWORK ADDR01
>000.000.000.000
#ROUTING TABLE2
#METRIC
>064
#ETHERNET ADDR
>0800832Annnn
#CONNECTION SPD.
>AUTO
*000.000.000.000
to *255.255.255.255
*000.000.000.000
to *255.255.255.255
#GETEWAY ADDR02
>000.000.000.000
#NETWORK ADDR02
>000.000.000.000
to
#GETEWAY ADDR10
>000.000.000.000
#NETWORK ADDR10
>000.000.000.000
*1 to 255
*AUTO
*100
*10
L