User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

Appendix-9
▼ Menu structure
Appendix
#DRAWING (
10
)
>NOP
#
PAPER NO.
(
10
)
>PAPER SOURCE
#PEN PAR. MODE
>DATA PRIORITY
#PEN0
to
N (
12
)
#PEN ADJUST (mm) / #PEN ADJUST (in)
>-0.00
#LINE DISPOSAL
>OFF
#IMAGE SCALE
>LINE DRAW. MODE
#SCREENING (
13
)
>LINE DRAW. MODE
#PEN PARAMETER (
11
)
#RASTER PARAM
*NOP
*EOP
*PAPER SOURCE
*PAPER TYPE
*OFF
*DATE PRIORITY
*PANEL PRIORITY
#WIDTH (mm) / #WIDTH (in)
>n *0.00 to 16.00
(0 to 0.629 inches)
#DENSITY (%)
>n *0 to 100
#CORNER
>ROUND *ROUND
*BUTT
#JOINT
>ROUND *ROUND
*MITERED
*-0.99 to 0.99
(-0.038 to 0.038 inches)
*OFF
*ON
*LINE DRAW. MODE
*PICTURE MODE
*LINE DRAW. MODE
*GRAPHICS MODE
*PICTURE MODE
E
E'
Note (
10
) DSCAN only
Note (
11
) HP-GL, DSCAN only
Note (
12
) HP-GL is 0 to 15
DSCAN is 1 to 32
Note (
13
) HP-GL, DSCAN, TIFF only