User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

14-43
▼Error log
Chapter 14 Troubleshooting
Type of Error Log
The errors are classified as follows.
The following log examples show the information saved in the log file.
Service Call Error (Classification: E)
Description : An unrecoverable error that needs a service person's
intervention.
Cause : Hardware or firmware is faulty.
Measure : If the device does not recover from this error after
turning the power off and on, please notify your dealer or
our service center of the displayed error message and
error condition.
*Log example of hard disc error
“E E56E-0401”
Operator Call (Classification: O)
Description : An error that the operator can fix.
Cause : No paper, no toner or paper jams.
Measure : Fix the cause to restore the device to its normal state.
*Log example of door open
“O DOOR2 open”