User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
14-35
▼When an error message appears
Chapter 14 Troubleshooting
■Controller errors
Description : This error message may appear if an unrecoverable and
fatal error occurs in each program module provided on
the controller of the device.
(1) Error in PDL module
(2) Error in engine control module
xxxx: Error code
edocrorrEnoitpircseD
F930ot0830
rorremargorP
09A0ot08A0
xxxx: Error code
Error code Description
0111 to 01FF
Program error0201 to 02FF
1000 to 1FFF
0301 to 03FF Hardware chip error
0401 to 04FF Hard disc error
0501 to 05FF Engine communication error
0601 to 06FF Scanner communication error
E F064-xxxx
Powe r Of f /On
E E56E-xxxx
Powe r Of f /On