User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
14-32
■Engine warning
Description : This error may occur when image data is transferred
from the controller to the engine for printing.
The drawing on which this error occurred may not be
printed correctly because image data for printing is not
transferred correctly.
Measure : If an error occurs successively, turn the power off and
on. If the device does not recover from this error after
turning the power off and on, please notify your dealer or
our service center of the displayed error message and
error condition.
xxxx: Error code
edocrorrEnoitpircseD
F009ot1009)rorrerefsnarteciveD(rorrepihcerawdraH
F109ot1109)rorrerefsnartrennacS(rorrepihcerawdraH
FF09ot1209)eruliafnoitarepO(rorrepihcerawdraH
W E56E-xxxx
Press Any Key