User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
14-21
▼When an error message appears
Chapter 14 Troubleshooting
Description : The nonvolatile memory (NVRAM) of the device has
been damaged. Usual printing can be performed, but
some functions that use this area may not operate
correctly.
Measure : If the device does not recover from this error by turning
the power off and on, please notify your dealer or our
service center of the displayed error message and error
condition.
Description : This message appears if there is an unprocessed job (jobs
standing by for processing) at powering on.
Measure : Select whether the job is deleted or not by pressing the
[Enter] key or [Cancel] key.
The operation goes in to time-out in about 10 seconds
unless the key is pressed, and the device starts with the
job saved.
If a job has been left at powering on
Job status Display Transaction
Standing for
processing
DELETE JOB?
Job is deleted by designation.
Processing -
Job is automatically moved to
"already processed" job.
Processed -
Jobs are automatically deleted in
order from the oldest job.
WNVRAMERROR
De l e t e Job?
Y=En t e r N=Cance l