User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
14-20
Warning
■Operator notice warning
Description : The saved job has been damaged, and thus the spool area
is initialized (When HDD is installed).
Measure : After 3 seconds, the message changes to “WAIT A
MOMENT” and then the device starts.
Description : The received data is in a format not supported by the
device, and thus the data was ignored.
Measure : Use the data in a format supported by the device.
Description : The spool area on the HDD has been damaged, and thus
the memory spool area is used (When HDD is installed).
Measure : If the device does not recover from this error when you
turn the power off and on, please notify your dealer or
our service center of the displayed error message and
error condition.
WSPOOL INITIALIZED
W Job Delete
WSPOOL ERROR