User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
14-15
▼When an error message appears
Chapter 14 Troubleshooting
■Top door (Door 6)
Description : The top door is open.
Measure : Close the top door.
■Fixation door (Door 7)
Description : The fixation door is open.
Measure : Close the fixation door.
■Manual paper feeding holder (Door 8)
Description : The manual paper feed holder is open, and thus the rolled
paper cannot be printed.
Measure : Close the manual paper feed holder.
Note: See door locations on the drawing at 1-11 and 1-12.
Close Door 6
Close Door 7
Close Door 8