User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

14-14
Door Open
If the door is opened, the following message appears on the Control
Panel.
■Roll 1 drawer (Door 1)
Description : The roll 1 drawer is open.
Measure : Close the roll 1 drawer.
■Roll 2 drawer (Door 2)
Description : The roll 2 drawer is open.
Measure : Close the roll 2 drawer.
■Manual feed drawer (Door 4)
Description : The manual feed drawer is open.
Measure : Close the manual feed drawer.
■Cutter door (Door 5)
Description : The cutter door is open.
Measure : Close the cutter door.
Note: See door locations on the drawing at 1-11 and 1-12.
Close Door 2
Close Door 1
Close Door 4
Close Door 5