User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
14-7
▼When an error message appears
Chapter 14 Troubleshooting
■Clearing paper jam in main body (cutter area)
1 Open the cutter door.
Loosen the two knobs and open the cutter door
gently.
2 Remove the jammed paper and close the cutter door.
After you closed the cutter door, the following
message appears on the Control Panel, and then
the plotting restarts from the drawing that
jammed.
Cutter door
(Door 5)
Wa i t a mome n t
Pr int 01/01
Wa i t : 012
F01 HPGL JobNo . 008✽
Open Doo r 5
Remove Paper
Knob