User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
14-5
▼When an error message appears
Chapter 14 Troubleshooting
3 Open the manual paper feed holder and the fixation
door.
4 Remove the jammed paper.
1 Lift the paper guide.
2 Remove the paper gently so that toner does
not spill.
◆ The fixation is very hot. Do not touch it.
Touching the fixation could cause you to
get burned.
If the jammed paper is not visible, the paper
may be jammed inside the main body (cutter
area). See “Clearing paper jam in main body
(cutter area)” (⇒ page 14-7).
Manual paper feed
holder (Door 8)
Fixation door
(Door 7)
Warning