User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
12-10
■FTP DATA TYPE
Specifies the initial value of the data transfer type when receiving ftp data.
<Parameter (choice input method)> : Default value
ASCII/BIN/BIN
■SNMP
Specifies the SNMP operation. When the setting is ON, SNMP is enabled.
The SNMP community name can be specified using the Web name.
<Parameter (choice input method)>
: Default value
ON/OFF
■SNMP VERSION
Specifies the SNMP version.
<Parameter (choice input method)> : Default value
V1/V2
■TRAP** (** : 01 - 02)
●MANAGER
Specifies the manager IP address to return TRAP.
When the following TRAP conditions are OFF, TRAP does not occur in
this setting.
<Parameter (numerical input method)>
000.000.000.000 to 255.255.255.255
Default value: 000.000.000.000
(TRAP is the same when it is OFF if not registered.)