User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
12-9
▼Setting items
Chapter 12 Ethernet parameter "ETHERNET"
■CONNECTION TYPE
Specifies the connection type.
<Parameter (choice input method)> : Default value
AUTO Automatically recognizes Full Duplex/ Half Duplex.
FULL Sets to Full Duplex.
HALF Sets to Half Duplex.
■HTTP PORT
Specifies the HTTP port when using the Web function.
<Parameter (numerical input method)>
0 to 65535
Default value: 80
■PORT TIMEOUT
Selects the closing time of TCP port. Operation starts when no data is
transmitted while being transferred.
<Parameter (choice input method)> : Default value
OFF Does not time out.
5 min Set to 5 minutes.
10 min Set to 10 minutes.
15 min Set to 15 minutes.
30 min Set to 30 minutes.