User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
12-6
ROUTING TABLE
Specifies the routing table of this device. It is used to connect this device
to a host of other network.
■GATEWAY ADDR
Specifies the Router IP address.
<Parameter (numerical input method)>
000.000.000.000 to 255.255.255.255
Default value: 000.000.000.000 (not set)
■NETWORK ADDR
Specifies the network address
<Parameter (numerical input method)>
000.000.000.000 to 255.255.255.255
Default value: 000.000.000.000
◆ If the gateway address is not specified, it is not displayed.
◆ When this setting value is "000.000.000.000," it means the
default routing is specified.
Notes