User`s guide

12-3
▼Setting items
Chapter 12 Ethernet parameter "ETHERNET"
uneMmetiyhcrareihdrihTmetiyhcrareihhtruoFmetiyhcrareihhtfiFretemaraP
MARAP.MMOC
TENREHTE#
SLIATEDPUTES#
EPYTATADPTF#
NIB/IICSA>
NIB/IICSA
NIB
PMNS#
FFO>
FFO
NO
NOISREVPMNS#
1V>
1V
2V
10PART#
REGENAM#
000.000.000.000>
dohtemtupnieciohC
RORRE#
NO>
NO
FFO
BOJ#
FFO>
FFO
)SSERDDAPI(NO
)TROP(NO
RDDAPI#
000.000.000.000>
dohtemtupnieciohC
?
)4etoN(
TROP#
LLA>
LLA
)5etoN(
10TROP
⋅
01TROP
20PART#
REGANAM#
000.000.000.000>
dohtemtupnieciohC
RORRE#
NO>
NO
FFO
BOJ#
FFO>
FFO
)SSERDDAPI(NO
)TROP(NO
RDDAPI#
000.000.000.000>
dohtemtupnieciohC
?
)4etoN(
TROP#
LLA>
LLA
)5etoN(
10TROP
⋅
01TROP
Note 1) Up to 10 ports including XPT, LPD, FTP can be specified.
The initial value is 1 port for each protocol.(XLF – – – – – – –)
Setting example: # PORT SELECT 1-10
>FFFXXXLLL_ ......In case of 3 ports for each protocol.
Note 2) Same as the IP address specified in the installing operation.
Note 3) Network address is indicated only when the "Gateway address" is specified.
Note 4) To be displayed only when the "TRAPnn job" is set to ON (IP address).
Note 5) To be displayed only when the "TRAPnn job" is set to ON (PORT).
Note 6) Not to be displayed when "DHCP" is set to enable.