User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix

11-16
When the administrator password is specified, the following password
verification window appears before proceeding to the menu screen.
Enter the administrator password according to the procedure given
below.
1 Press the [ ] key.
Press the [ ] key is pressed, the digit of numeric
value can be moved.
2 Press the [ ] or [ ] key.
If the [ ] or [ ] key is pressed, numeric value
can be changed.
Repeat the Steps 1 and 2 to enter the eight-digit administrator password.
3 Press the [Enter] key.
If the [Enter] key is pressed, the screen changes
as shown below.
Me n u Mo d e
#ADMI N PASSWORD
>
00000000
[Enter] to Conf irm
Me nu Mo d e
#ADMI N PASSWORD
>0
000000
[Enter] to Conf irm
Me nu Mo d e
#ADMI N PASSWORD
>0
200000
[Enter] to Conf irm
Me nu Mo d e
Me nu
#SETUP