User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
11-15
Chapter 11 "SYSTEM" menu
▼Setting items
LANGUAGE
Switches the message display on the LCD.
<Parameter (choice input method)> : Default value
JAPANESE/ENGLISH/CHINESE
LENGTH UNITS
Switches the length unit (millimeter or inch).
<Parameter (choice input method)> : Default value
MILLIMETERS/INCHES
ADMIN PASSWORD
Specifies the administrator password. This password prevents the
settings of the plotter from being changed.
<Parameter (numerical value input method)>
00000000 to 99999999 Default value: 00000000
◆ Write the administrator password down for remembrance
sake. If you should forget the administrator password, the
plotter should be initialized, in which case all the settings
will return to the factory default settings.
Note