User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
11-13
Chapter 11 "SYSTEM" menu
▼Setting items
SCAN START
Allows for determining whether scan is started with START key or
automatically when the original is loaded.
<Parameter (choice input method)> : Default value
START button/Original set
MODE TIMEOUT
Allows for setting of the time until the mode transits to STAND-BY if
there is no key operation.
<Parameter (choice input method)> : Default value
30 sec Set to 30 seconds.
1 min Set to 1 minute.
2 min Set to 2 minuets.
3 min Set to 3 minutes.
COPY SETTING
Since this setting is only for Japan, leave the setting as it is.