User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
11-12
CHINA SIZE
Specifies the roll size of the Chinese series handled by this device.
■Each size paper of Chinese series
Specifies the paper size from A0 to A3 of the Chinese series.
◆ This item is displayed only when the CHINESE SERIES of
the ENABLE SERIES in the system menu is ON.
Menu Second hierarchy item Parameter
SYSTEM
#CHINA SIZE
#CHINA A0
>914 mm (36 inches)
914 mm (36 inches)
910 mm (35.8 inches)
900 mm (35.4 inches)
880 mm (34.6 inches)
#CHINA A1
>620 mm (24.4 inches)
620 mm (24.4 inches)
610 mm (24 inches)
#CHINA A2
>450 mm (17.7 inches)
450 mm (17.7 inches)
440 mm (17.3 inches)
#CHINA A3
>310 mm (12.2 inches)
310 mm (12.2 inches)
297 mm (11.7 inches)
Note