User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
11-9
Chapter 11 "SYSTEM" menu
▼Setting items
MAP SERIES ROLL
700 mm (27.6 inches), 500 mm (19.7 inches)
DIN SERIES ROLL
707 mm (27.8 inches), 500 mm (19.7 inches)
CHINA SEIRIES ROLL
914 mm (36 inches), 910 mm (35.8 inches), 900 mm (35.4 inches),
880 mm (34.6 inches), 620 mm (24.4 inches), 610 mm (24 inches),
450 mm (17.7 inches), 440 mm (17.3 inches), 310 mm (12.2 inches),
297 mm (11.7 inches)
<Parameter (choice input method)> : Default value
OFF/ON
◆ The default value varies depending on the INITIAL
SETTING.
◆ All of these parameters cannot be set to OFF.
◆ When this parameter is changed from ON to OFF, the
following related parameters must be initialized.
• MEDIA SERIES in the paper menu
• Automatic paper feed series in the setup menu
Notes