User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
11-7
Chapter 11 "SYSTEM" menu
▼Setting items
■Terioplot
Specifies whether to use Terioplot or not in operation.
For the operation of Terioplot, refer to Chapter 13 and the documents
supplied with the “Terioplot” software package.
●Terioplot
Specifies whether to use Terioplot or not in operation.
<Parameter (choice input method)> : Default value
OFF/ON
●Terioplot ADDR
Specifies the IP address of the computer where Terioplot is installed.
<Parameter (numerical value input method)>
000.000.000.000 to 255.255.255.255 Default value: 000.000.000.000
WEB LOCK
Specifies whether the setup authority from the WEB browser is given to a
user administrator or subordinate.
<Parameter (choice input method)> : Default value
OFF/ON