User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
11-6
●TIMEOUT (100msec.)
Specifies the time at which the data reception is considered to have been
completed after the data transmission is discontinued (unit: 100 msec).
<Parameter (numerical value input method)>
1 to 18000 Default value: 300
■USB
Specifies the USB interface for communication.
This menu is displayed only when the USB interface is installed.
●TIMEOUT (sec)
Specifies the time at which communication is discontinued after the host
device is hung up during communication for some reason (unit: second).
<Parameter (numerical value input method)>
0 to 99 Default value: 10
■PlotDataToFile
Since this setting is only for Japan, leave the setting as it is.