User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
11-5
Chapter 11 "SYSTEM" menu
▼Setting items
●TWAIN TIME OUT
Allows for setting of the time-out time if no response is returned from the
TWAIN driver when this driver is used for connection. When the time set
here elapses, the device can exit from the TWAIN mode.
<Parameter (choice execution method)>
: Default value
30 min Time out after 30 minutes
60 min Time out after 60 minutes
90 min Time out after 90 minutes
■PARALLEL
Specifies the parallel interface for communication.
Only when the parallel interface installed is displayed.
●TIMING MODE
Specifies the communication conditions (signal timing) for the parallel
interface.
<Parameter (choice execution method)>
: Default value
NORMAL/FAST/SLOW
When the NORMAL, FAST or SLOW parameter is selected, fixed
values listed in the table below are automatically specified.
Initial value of communication parameter (parallel)
metIedomtsaFedomlamroNedomwolS
gnimitEBORTSegdellaFegdellaFegdellaF
emit-noKCAcesn0094.2 µ ces6.3 µ ces
htgneleslupKCAcesn0094.2 µ ces3µ ces
gnimitffoYSUBegdeesirKCAegdeesirKCAegdeesirKCA