User`s guide

9-2
Setting items
The protocol menu is used to set up the communication protocol.
This device is provided with the interface connector for the Ethernet
interface as the standard specification. The Ethernet interface is provided
with 10 logical ports. In addition, when parallel and USB interfaces are
installed, two types of interface connectors are provided for the parallel
interface and USB interface. Thus, this device can receive data from up
to 12 computers at the same time.
This menu allows for setting of the items related with the protocol by
channel and port.
Setting of the number of ports and protocol used in this device should be
changed by the communication parameter, "PORT SELECT", in the
system menu (initial values of ports No. and protocols are port 1 = XPT,
port 2 = LPD, port 3 = FTP).
uneMmetiyhcrareihtsriFmetiyhcrareihdnoceSretemaraP
LOCOTORP
LOCOTORP
TPX:1TROP#
TCELESLDP#
CTDH>
CTDH
TROPTPX#
0019>
0019
LOCOTORP
DPL:2TROP#
TCELESLDP#
CTDH>
CTDH
EMANRETNIRP#
20PL>
20PL
LOCOTORP
PTF:3TROP#
TCELESLDP#
CTDH>
CTDH
EMANRESU#
30PTF>
30PTF
:
:
LOCOTORP
LELLARAP#
TCELESLDP#
CTDH>
CTDH
Note) After this menu is changed, the system is reset.
When there is a job standing for processing, you can only refer to this menu.
If you only refer to the menu and do not change it, the system returns to offline
condition.
Disabled port is not displayed.
The total number of usable ports of XPT, LPD, and FTP is 10.
* XPT: Raw Protocol (socket)
Me n u Mo d e
PROTOCOL
#PORT 1 : XPT