User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
6-3
▼Setting items
Chapter 6 "DEVICE" menu
POWER SAVE
Specifies the time until the power saving mode is entered to minimize the
power consumption.
<Parameter (choice input method)> : Default value
15 min Device enters the power saving mode after being left for 15
minutes.
30 min Device enters the power saving mode after being left for 30
minutes.
60 min Device enters the power saving mode after being left for 60
minutes.
90 min Device enters the power saving mode after being left for 90
minutes.
235 min Device enters the power saving mode after being left for 235
minutes.
• After completion of plotting, when the preset time for waiting has
elapsed, the device automatically enters the power saving mode.
• When data is received, the power saving mode is automatically reset.
• By pressing the [CANCEL] key, the power saving mode is
automatically reset.