User`s guide

Table Of Contents

5-32

The joints can be specified with the parameters illustrated below:

• Any combination other than CORNER = "ROUND" and JOINT =

"ROUND" may take long time for plotting.

• Lines not jointed (which are not drawn with one stroke) are excluded.

• If the attributes of lines (line color, line width, line type) change,

treatment for joints may not be performed.

• The outermost line of the plot may not be treated for joints.

■PEN ADJUST (mm) / PEN ADJUST (in)

Allows for setting of the pen width adjust value. Plots can be produced

with a pen width larger or smaller than the pen width preset with the data

or on the panel by the adjust value in the range of the maximum pen width

16 mm (0.63 inches) and minimum width 1 dot.

This setting is performed on the third hierarchy.

-0.99 - +0.99 (-0.038 to +0.038 inches) Default value = 0

ROUND

MITERED

MITERED length