User`s guide

Table Of Contents

5-22

■SCALE X (%)

SCALE Y (%)

When setting "SCALE MODE = MANUAL SCALE," values of the scale

applied to X and Y directions of the drawing are set up.

This setting is performed on the third hierarchy.

0.01 to 1000.00 Default value = 100

This setting is enabled when setting "SCALE MODE = MANUAL

SCALE." When it is set to 100%, the plot is produced in 1-to-1

magnification.

■PEN WIDTH SCALE (HP-GL, DSCAN only)

Sets the scaling down method, when the drawing is scaled down (in the

same X and Y proportion). This setting is performed on the third

hierarchy.

<Parameter (choice input method)> : Default value

ON Line width or interval between points are also scaled down.

Maximum line width is 16 mm (0.63 inches).

OFF Line width or interval between points are not scaled down.

■FIX SCALE A

FIX SCALE 9"

FIX SCALE 8.5"

Allows for setting the method of automatic scale from one fixed form to

another when setting "SCALE MODE = MANUAL SCALE." This

setting is disabled when plotting in the actual length or expanded fixed

form. This setting is performed on the third hierarchy.