User`s guide
Table Of Contents
- Introduction
- TABLE OF CONTENTS
- Chapter 1 Getting started
- Chapter 2 Basic operations
- Plotting procedures overview
- Turning the power on and off
- Installation operations
- Online and offline
- Replacing paper rolls
- Replacing the toner
- Replacing the waste toner bottle
- Replacing the process cartridge
- Manual paper feeding (cut paper)
- Pause, continue, cancel (and additional printing)
- Web function
- Cleaning the exterior
- Using paper of new standard series
- Using paper of Chinese standard series
- Limiting rolls to be used
- Chapter 3 Menu overview
- Chapter 4 Basic Menu Operation
- Chapter 5 "SETUP" Menu
- Chapter 6 "DEVICE" menu
- Chapter 7 "PAPER" menu
- Chapter 8 "FUNCTION" menu
- Chapter 9 "PROTOCOL" menu
- Chapter 10 "RESET" menu
- Chapter 11 "SYSTEM" menu
- Chapter 12 Ethernet parameter "ETHERNET"
- Chapter 13 Terioplot
- Chapter 14 Troubleshooting
- Appendix
5-19
▼Setting parameter Items
Chapter 5 "SETUP" Menu
■WRITE MODE
Allows for setting of the drawing overlap method. When the HP-GL data is
used for setting the WRITE MODE, the data setting is enabled. The default
setting is "OR WRITING". This setting is changed on the third hierarchy.
<Parameter (choice input method)> : Default value
OR WRITING Drawing is overlapped.
OVER WRITING Drawing is overwritten.
■MIRROR
Allows for setting whether to produce a plot by turning over the plot
around the drawing center line in parallel with the X axis (line
symmetry).
This setting is performed on the third hierarchy.
<Parameter (choice input method)>
: Default value
OFF Mirror plotting is not performed.
ON Mirror plotting is performed.
Drawing center
line in parallel
with X axis
XX
At OFF
At ON
YY